These billet 6061 aluminum hubs are a great lightweight option for your Ford F106 axle. These hubs weight 24 pounds per set, are designed for single rear wheel drum acle hubs and accept factory races, bearing and seals. They come standard with 3/4-16 wheel studs installed. Races, bearings and seals will need to be installed. If you would like custom wheel flange location, please contact us.

These open carriers are made from new billet material and a great option for replacing that older worn-out carrier in your F106. Steel assemblies are the same as OEM carriers, billet aluminum carriers can be used when weight is a concern. Carriers accept stock internal components, stock bearings and come with new hardware

These F106 spools are turned from 4140 forged steel, splined, heat treated and then finish turned on all locating surfaces. Spools can be splined for 19 or 34 spline axle shafts.

These SQHD spools are turned from 4140 steel, splined, heat treated and then finish-turned on all locating surfaces. These spools are typically splined for 2 1/16" 32 spline axle shafts but other splines can be done upon request.

These third member housings are made from billet 6061 aluminum and weight just 24lbs., compared to the cast iron version which weighs 49lbs. All third members come with a billet pinion support, 7075 aluminum main bearing caps, carrier adjusters, replaceable pinion support and load bolt.

This billet case has added material in weak points of the stock casting making this stronger than the original housing.

These third member housings are made from billet 6061 aluminum. All third members come with a billet pinion support, 7075 aluminum main bearing caps, carrier adjusters, replaceable pinion support and load bolt. This billet case has added material in weak points of the stock casting making this stronger than the original housing. This is the perfect part to replace that tired, twisted heavy cast housing.